Saturday, August 5, 2006

Assembling The Mounting Plate

It's still very much a work in progress, but I figured out how to mount the power supplies without gutting the phono stage layout beneath. I'm going to use a mounting plate to mount the boards on. Take a look below. Tell me, honestly, are you CJ fans out there shocked at the metamorphosis happening? :) More when I actually figure out which order the screws have to go in.  Posted by Picasa
Posted by at

2 comments:

  1. Tre'August 7, 2006 at 4:55 PM

    Can we see a schematic?

    ReplyDelete
  2. Nigel TufnelAugust 10, 2006 at 5:18 AM

    The schematic is up. :) It's a little off though, the resistor under the first two diodes should be 360K, but like I said, it doesn't really matter.

    The same resistor on the main board could be changed to 560K if you wanted to match the PV-12

    ReplyDelete

Subscribe to: Post Comments (Atom)